![]() ![]() Does anyone recommend a particular brand? They are all made in China using the same materials, etc. In the meantime- I am looking for suggestions- possibly buying three new 12 V 12 AHM batteries. I have not re-assembled because I decided to install a new tire before re-installing in the frame. I took the entire assembly apart and cleaned and lubricated all parts looking for mechanical parasitic drag form a bad bearing, or dragging disc brake pad. The results were essentially the same Moderate RPM without the lag in spooling. I suspected a bad Hall-sensor in the throttle and tried running the motor directly from the Battery Pak. Turning on the power switch and operating at full throttle resulted in very slow to moderate RPM of the rear wheel. I Checked the Master connection and it measured 39.1 volts. I checked them with Multi Meter and each Batt measured 12.5 volts. The seller advised the Batteries were a year old but still held full charge. It is 36 volt with the Direct Drive Motor. Parts can be purchased at any time on our website.I recently picked up a used Currie E Zip 1000. SUPPORTTo request support or initiate a Warranty Claim, please complete a Warranty covers defects in material and workmanship and DOES NOT COVER repairsĭue to operation. Any damaged or missing delivery items will be replaced. Manufacturer covers parts only and labor is not covered The Manufacturer Warranty DOES NOT COVER REPAIRS. Often times, theyĪll Parts are available for online ordering. These shops can help with Assembly, Repair or Maintenance. May not be many Go Kart or Scooter shops in your area. Break-in Service must be performed after 1 hour of operation and can include: engine oil service, check and tighten all nuts and bolts, check and adjust cables, throttle, brakes, chain and all other systems. Initial Setup can include installing: wheels, seats, roll cage, lights, battery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |